75 Ton H-Frame Electric Hydraulic Shop Press with Hand Winch, 110V Motor, Fully Welded Steel Frame, Safety Guard, Foot Pedal Control, HSP75E

Rated Capacity
75 Tons
Pump Type
Single-acting
Operation Type
Electric Hydraulic Operation
Voltage
110V / 60Hz
Ram Stroke
9.8 in
Power
2 HP（1.5 kW）
Ram Diameter
3 in
Revolutions Per Minute
1800 RPM
Cylinder Bore
5 in
Working Pressure – Low Pressure Stage
725 PSI
Ram Range of Movement
3 in Left / Right from Center
Working Pressure – High Pressure Stage
9135 PSI
Bed Depth
9.5 in
Flow Rate – Low Pressure Stage
1.74 GPM
Bed Height
10.2 in
Flow Rate – High Pressure Stage
0.48 GPM
Minimum Ram to Bed
10 in
Usable Oil Capacity
7.9 US Gallons
Maximum Ram to Bed
30 in
Oil Tank Capacity
10 US Gallons
Number of Bed Adjustment Holes
9
Recommended Hydraulic Oil
AW32 Hydraulic Oil
Bed Adjustment Hole Spacing
4.7 in
Pump Size
25.5 x 16 x 12 in
Frame Construction
Fully Welded Heavy-Duty H-Frame
Gauge Type
4 in Oil-Filled Pressure Gauge
Assembled Size (H x D x W)
79.2 × 29.6 × 56.7 in
Included Accessories
Protective Grid Guard, Hand Winch, V-Blocks
Internal Frame Width
31.5 in
Packing Size (LxWxH)
81.5 x 42.9 x 16.9 in
Protective Grid Guard Size
27 x 24 in
Weight (N.W/G.W.)
928.0 lbs / 1031.7 lbs
Ram Retraction
Twin Springs
WARNlNG: This product can expose you to chemicals including engine exhaust (including diesel engine exhaust when equipped),lead and lead compounds, mineral oils, soots, phthalates, and carbon monoxide which are known to the State of California to cause cancer and birth defects or other reproductive harm. For more information go to www.P65Warnings.ca.gov.Certain specification(s) are based on engineering calculations and are not actual measurements. Specification(s) are provided for comparison purposes only and are subject to change without notice. Specification(s)  for your individual equipment will vary based on normal variations in design, manufacturing, operating conditions, and other factors.